Unroll a sufficient amount of screening to overhang the spline groove by about 1/8″. Miter the corner of the screening using your tin snips

With your Spline Roller, begin at the corner and roll the screening only — not with the spline — into the spline groove. As you roll, the screening will have a tendency to pull in the direction you are rolling. To prevent this, put your free hand and arm on the fabric. Apply enough pressure to keep the screening from bunching.

When the screening is rolled in on Side #1, roll the spline in on that side.

Trim the screening so that it overhangs the spline groove by about 1/8″. Roll that overhang into the spline groove. Use your free hand to keep the screening from bunching. Don’t roll in the spline.

Trim the screening so that it overhangs the spline groove by about 1/8″. Roll that overhang into the spline groove.

Trim the right side so that the aluminum screening overhangs the spline groove by about 1/8″. Miter the corners.

Roll the screening into the spline groove.

Cut the spline at the corner. If necessary, use a flat edge screw driver to push the spline down neatly into each corner.